Discharge-test routines

Exit and emergency lighting testing

Exit signs and emergency lights carry batteries that quietly die in place. The maintenance framework requires periodic discharge tests, running the fittings on battery for the prescribed duration, with failures repaired and logged. It is one of the most commonly failed measures in older buildings simply because nobody runs the tests.

Scope

What this covers

  • Programmed discharge testing across all fittings

  • Battery, lamp and fitting replacement where tests fail

  • Updated fitting registers so every luminaire is accounted for

  • Logbook entries that stand behind the annual statement

Timing

When it's needed

Any building with emergency lighting needs the test cycle running continuously. A dark stairwell during a real evacuation is the failure mode; a practitioner refusing to endorse the measure at statement time is the administrative version of the same problem.

Never wedge open a fire door, block an exit path or leave a fire system isolated after works without a plan to restore it. If a measure is found inoperative in an occupied building, treat it as urgent and escalate the defect the day it is found.

Quote variables

What shapes the scope

In NSW, the assessments behind an annual fire safety statement must be carried out by an accredited practitioner (fire safety), accreditation currently operates under the Fire Protection Association Australia scheme, while rectification work must be done by appropriately licensed or qualified trades for each measure. Ask who is accrediting the assessment and who is doing the physical work, and verify both.

Maintenance services

Start your quote

Send through the job details and we'll connect you with a licensed provider who can quote this work.

If this is an emergency or anyone is at immediate risk, contact the relevant emergency service or your network or utility operator directly instead of using this form.